Installation Video

  Step One

logo logo

Complete the digging of your trench at 6’8” deep. During installation, ensure the stability of the trench walls as necessary.
See http://work.alberta.ca/documents/WHS-LEG_ohsc_p32.pdf for guidance.

Your STOCKBOSS will then sit 20” above the ground level, measuring from the top of the drinking bowl.
This is the recommended height for cattle and horses.

  NOTE!   For smaller livestock such as sheep, the STOCKBOSS can be installed deeper

  IMPORTANT NOTE!   Open & close the “shut off valve” before and after installation of brass fitting (prior to burying in the ground)

  Step Two

logo logo

Remove StockBoss float tube lid by removing shipping screws

  Important Note:  Open & close the “shut off valve” before and after installation of brass fitting (prior to burying in the ground)

  Step Three

logo logo

logo logo

Screw in the BRASS ELBOW at bottom of the waterer, at a downward facing 45 degree angle.
To prevent internal plumbing components from turning during tightening of the elbow, secure the fitting on the waterer with a wrench while tightening.

  NOTE!   You can tape the fitting shut to prevent soil and debris from collecting inside the elbow

  CAUTION:   Ensure the fitting on the waterer does NOT turn

  Step Four

logo logo

Secure a suitable rope or cable around top of the StockBoss, then lower down into the trench on a level bed.

  NOTE!    the STOCKBOSS weighs approximately 400 lbs. (180 kg)

  Step Five

logo logo

Once the STOCKBOSS is firmly placed on the bed of the trench, attach your black poly pipe supply line to the BRASS ELBOW. Use a hose clamp (not supplied) to fasten securely.

  NOTE!   If using high density hose or larger diameter hose a short flexible hose may be required

  Step Six

logo logo logo logo

Install Float Assembly in the float column, install the standpipe, put a small amount of grease or Vaseline on the “0” ring on the pitless, then slide pitless into place & attach float assembly. If the standpipe has already been installed (by the mfg.), apply gentle downward pressure to the standpipe to ensure it is securely seated in the pitless

  NOTE!   Checking for alignment – if your standpipe is NOT pointing vertical – then turn fitting at bottom of waterer with your wrench until it is vertical.

  NOTE!   ensure the float valve assembly is centered

  Step Seven

logo logo logo logo

With the water supply line securely attached and the standpipe in vertical position – proceed to level and back fill. Use SAND as fill for the initial 3 feet and then fill the trench with the initial dirt that had been removed.

  NOTE!   Continually ensure the waterer is level during backfilling

  NOTE!   Sand is ideal as it sifts and packs firmly around the bottom of the unit. It is also preferred as large chunks of soil & debris could cause collapse of the hoses

  Step Eight

logo logo logo logo

Remove the shipping screws from the DRINKING BASKETS and place hold-down weights into baskets to prevent them floating up. Rocks are recommended and work great.

  Step Nine

logo logo

After the water supply is turned on to the waterer. Turn the water on for the waterer by turning the steel rod located on top of the unit one quarter turn with the STOCKBOSS Valve Tool ( available for purchase on the parts list )

  Step Ten

Set the float to the desired water level.

  Tips

To install/remove the tight fitting lid: use a rubber hammer and tap in the desired direction

  NOTE!   the lid TURNS ON

To prevent ice crystals from forming in the float area – add one gallon of mineral oil (available for purchase on the web site) to float valve compartment
To keep water fresh & clean – remove basket – pump out the waterer & replace basket (recommended yearly)
CAUTION: DO NOT DROP THE WATERER